Stuart Turner 6a Castings?

Pitchfire · Post by **Pitchfire** » Tue Jun 12, 2012 4:33 am

Where can I get Stuart Turner 6a Castings? Are they still available?

artemis · Post by **artemis** » Wed Jun 13, 2012 5:28 am

Pitchfire wrote:Where can I get Stuart Turner 6a Castings? Are they still available?

They're not on the Stuart website so, unless you can find some hobby shop that has a back room full of old Stuart kits, you're out of luck.

steamboatjack · Post by **steamboatjack** » Wed Jun 13, 2012 10:24 am

I have e-mailed Stuart on this matter as they are still listed in the "spares section" I will post a reply should I receive one.
Regards
Jack

Pitchfire · Post by **Pitchfire** » Wed Jun 13, 2012 4:17 pm

Thanks, I have the blueprints reprinted in "Steamboats and Modern Steam Launches, July/August 1961," but obviously castings would make the job much easier.

steamboatjack · Post by **steamboatjack** » Sat Jun 16, 2012 7:27 am

Folks,
Stuart's have informed me that the 6A castings are "out of stock" and that they will be available again in about three months.
Regards Jack

tempus fugit · Post by **tempus fugit** » Sat Jun 16, 2012 8:38 pm

Stuart Turner has been sold to the Bridport Foundry in Dorset. They cast the Plastow traction engine
range of models. Very nice people to deal with.

The Steamboating Forum

Stuart Turner 6a Castings?

Stuart Turner 6a Castings?

Re: Stuart Turner 6a Castings?

Re: Stuart Turner 6a Castings?

Re: Stuart Turner 6a Castings?

Re: Stuart Turner 6a Castings?

Re: Stuart Turner 6a Castings?