Tube cutter would make a neater job though, and probably with fewer failures.
steam gauge glass
-
Mike Rometer
- Full Steam Ahead
- Posts: 936
- Joined: Sat Aug 13, 2011 6:41 pm
- Boat Name: B.N.Y.S.
- Location: Middle Earth
Re: steam gauge glass
Personally I've never had any trouble cutting water gauge glasses, I just nick them round on the corner of the off-hand grinder wheel, and snap them.
Tube cutter would make a neater job though, and probably with fewer failures.
Tube cutter would make a neater job though, and probably with fewer failures.
Retirement is about doing what floats your boat!
A BODGE : - A Bit Of Damn Good Engineering.
A BODGE : - A Bit Of Damn Good Engineering.