Page 1 of 1
Bolt for offset holes.
Posted: Tue May 22, 2018 12:14 pm
by RGSP
We all get hole positioning wrong sometimes. Here is a possible solution.
- Post dolly bolt.jpg (49.28 KiB) Viewed 5092 times
Re: Bolt for offset holes.
Posted: Tue May 22, 2018 12:28 pm
by Lopez Mike
I have people bring bolts like that into the shop once in a while.
"Can you make me one like this?"
"It will take me a few minutes with a hammer."
Re: Bolt for offset holes.
Posted: Tue May 22, 2018 3:31 pm
by RGSP
Lopez Mike wrote:I have people bring bolts like that into the shop once in a while.
"Can you make me one like this?"
"It will take me a few minutes with a hammer."
Just between ourselves, this one took well into the hundreds of blows of a 14lb sledge, before its twin broke.
Re: Bolt for offset holes.
Posted: Wed May 23, 2018 2:44 am
by Lopez Mike
Just between you and I, my grandmother used to refer to such a tool as an Irish Voting Machine. From her I was exposed to an endless supply of Celtic jokes.