We all get hole positioning wrong sometimes. Here is a possible solution.
Bolt for offset holes.
- Lopez Mike
- Full Steam Ahead
- Posts: 1903
- Joined: Wed Dec 07, 2011 6:41 am
- Boat Name: S.L. Spiffy
- Location: Lopez Island, Washington State, USA
Re: Bolt for offset holes.
I have people bring bolts like that into the shop once in a while.
"Can you make me one like this?"
"It will take me a few minutes with a hammer."
"Can you make me one like this?"
"It will take me a few minutes with a hammer."
If you think you are too small to make a difference, try sleeping with a mosquito.
Dalai Lama
Dalai Lama
-
- Full Steam Ahead
- Posts: 246
- Joined: Mon Dec 14, 2015 2:12 pm
- Boat Name: Platypus, Shelduck
- Location: Very eastern England
Re: Bolt for offset holes.
Just between ourselves, this one took well into the hundreds of blows of a 14lb sledge, before its twin broke.Lopez Mike wrote:I have people bring bolts like that into the shop once in a while.
"Can you make me one like this?"
"It will take me a few minutes with a hammer."
- Lopez Mike
- Full Steam Ahead
- Posts: 1903
- Joined: Wed Dec 07, 2011 6:41 am
- Boat Name: S.L. Spiffy
- Location: Lopez Island, Washington State, USA
Re: Bolt for offset holes.
Just between you and I, my grandmother used to refer to such a tool as an Irish Voting Machine. From her I was exposed to an endless supply of Celtic jokes.
If you think you are too small to make a difference, try sleeping with a mosquito.
Dalai Lama
Dalai Lama