Hi folks -
Rainbow's engine has a really poor HP valve rod guide design, so I'm redoing that by making a much stronger guide bolted to the valve chest and adding a guide for the top of the valve rod in the steam chest. This is because due to the short height of the engine, the distance between the valve rod guide and the bottom of the steam chest is quite small. The material for the guide rod bushing will be oillite sintered bronze, but for the top of the steam chest I'd like to use a material I can thread 5/8"-18. Any suggestions? I'd considered making the top bushing from brass and babbiting it and reaming to size, but I'm not sure how it will deal with the ~350 F we have at 150 psig working pressure. Phosphor bronze is also an option.
Any ideas + rationale for this?
Thanks -
- Bart
bearing material inside steam chest
- barts
- Full Steam Ahead
- Posts: 1069
- Joined: Wed Nov 18, 2009 6:08 am
- Boat Name: Otter, Rainbow
- Location: Lopez Island, WA and sometimes Menlo Park, CA
- Contact:
bearing material inside steam chest
-------
Bart Smaalders http://smaalders.net/barts Lopez Island, WA
Bart Smaalders http://smaalders.net/barts Lopez Island, WA
- dampfspieler
- Full Steam Ahead
- Posts: 254
- Joined: Wed Nov 18, 2009 6:59 am
- Boat Name: No Boat Yet
- Location: Neubrandenburg, Germany
- Contact:
Re: bearing material inside steam chest
Hi Bart,
i prefer gunmetal for that part. The valve rod should have a small flat part a bit longer than valve stroke to prevent it from vacuum in the chamber above the rod.
Here some Pics.
The Valve rod Valve rod in place in valve chest complete cylinder The running engine - my little steam logging loco
Best Dietrich
i prefer gunmetal for that part. The valve rod should have a small flat part a bit longer than valve stroke to prevent it from vacuum in the chamber above the rod.
Here some Pics.
The Valve rod Valve rod in place in valve chest complete cylinder The running engine - my little steam logging loco
Best Dietrich
- Kelly Anderson
- Full Steam Ahead
- Posts: 172
- Joined: Fri Feb 11, 2011 1:28 am
- Boat Name: Vividus
- Location: Strasburg, PA
- Contact:
Re: bearing material inside steam chest
Cast iron will be fine.
It was not easy to convince Allnutt. All his shop training had given him a profound prejudice against inexact work, experimental work, hit-or-miss work.